VANCOUVER, BC, May 21, 2021 /CNW/ - New Found Gold Corp. ("New Found" or the "Company") (TSXV: NFG) (OTC: NFGFF) is pleased to announce assay results from an additional four holes drilled at the Keats Zone ("Keats"). These holes were drilled as part of the Company's ongoing 200,000m diamond drill program at its 100%-owned Queensway Project ("Queensway"), located on the Trans-Canada Highway 15km west of Gander, Newfoundland.
Figure 1. Keats Main Zone Long Section (CNW Group/New Found Gold Corp.)
Figure 1. Keats Main Zone Long Section (table) (CNW Group/New Found Gold Corp.)
Figure 2. Keats Plan View (CNW Group/New Found Gold Corp.)
Figure 3. Example gold mineralization from NFGC-21-182. From drill core interval between 285m and 321m down hole. Note that these photos are not intended to be representative of gold mineralization in hole NFGC-21-182. (CNW Group/New Found Gold Corp.)
Figure 3. Example gold mineralization from NFGC-21-182, From drill core interval between 285m and 321m down hole. Note that these photos are not intended to be representative of gold mineralization in hole NFGC-21-182. (CNW Group/New Found Gold Corp.)
Figure 3. Example gold mineralization from NFGC-21-182. From drill core interval between 285m and 321m down hole. Note that these photos are not intended to be representative of gold mineralization in hole NFGC-21-182. (CNW Group/New Found Gold Corp.)
Table 2: Summary of results reported in this release. (CNW Group/New Found Gold Corp.)
Table 3: Location details of drill holes reported on in this release. (CNW Group/New Found Gold Corp.)
*Note that the host structures are interpreted to be steeply dipping and true widths are generally estimated to be 60% to 80% of reported intervals. Infill veining in secondary structures with multiple orientations crosscutting the primary host structures are commonly observed in drill core which could result in additional variability in true width. Intervals are calculated at a 1 g/t Au cut-off grade; grades have not been capped in the averaging. This table shows highlight intervals, a number of these holes returned additional intervals of gold mineralization as reported in Table 2 below.
The interval of 146.2 g/t Au over 25.6m in NFGC-21-182 is a 65m down-plunge step-out to the south from the previously furthest south high-grade intercept (hole NFGC-21-143, 63.7 g/t Au over 8.4m and 16.9 g/t Au over 2.5m, see New Found news release April 27, 2021) and is the deepest assay interval returned to date at Keats (see Figure 1).
The high-grade zone at Keats has now been drill defined over 425m in the down-plunge direction. The zone remains open and step-out drilling is continuing to the south, vertically above and below this zone, and to the north.
Denis Laviolette President of New Found, stated: "The interval of 146.2g/t over 25.6m in hole NFGC-21-182 has a grade x width of over 3,700 g/t Au x m, the highest to date on this metric at Keats, benchmarked against a long list of outstanding holes. Very significantly, as a step out 65m down plunge and as the furthest down-plunge hole and the deepest assay interval returned to date at Keats, this hole demonstrates that the outstanding zone of high-grade gold at Keats is continuing and perhaps strengthening with depth. We couldn't be more excited to be continuing to intercept such a phenomenal interval on such a large step-out down plunge at Keats and this continues to build our confidence that Keats is a very significant high-grade gold discovery."
Note: Au g/t x m calculations include all Keats Main intervals for each hole as reported in Table 2.
Core Photos, Hole NFGC-21-182
Drillhole Details
*Note that the host structures are interpreted to be steeply dipping and true widths are generally estimated to be 60% to 80% of reported intervals. Infill veining in secondary structures with multiple orientations crosscutting the primary host structures are commonly observed in drill core which could result in additional variability in true width. Intervals are calculated at a 1 g/t Au cut-off grade; grades have not been capped in the averaging.
Sampling, Sub-sampling and Laboratory True widths of the intercepts reported in this press release have yet to be determined but are estimated to be 60% to 80% of reported core lengths. Infill veining in secondary structures with multiple orientations crosscutting the primary host structures are commonly observed in drill core which could result in additional variability in true width. Assays are uncut, and calculated intervals are reported over a minimum length of 2 meters using a lower cut-off of 1.0 g/t Au. All HQ split core assays reported were obtained by either complete sample metallic screen/fire assay or standard 30-gram fire-assaying with ICP finish at ALS Minerals in Vancouver, British Columbia, or by entire sample screened metallic screen fire assay at Eastern Analytical in Springdale, Newfoundland. The complete sample metallic screen assay method is selected by the geologist when samples contain coarse gold or any samples displaying gold initial fire assay values greater than 1.0 g/t Au. Drill program design, Quality Assurance/Quality Control and interpretation of results is performed by qualified persons employing a Quality Assurance/Quality Control program consistent with National Instrument 43-101 and industry best practices. Standards and blanks are included with every 20 samples for Quality Assurance/Quality Control purposes by the Company as well as the lab. Approximately 5% of sample pulps are sent to secondary laboratories for check assays.
Qualified Person The technical content disclosed in this press release was reviewed and approved by Greg Matheson, P. Geo., Chief Operating Officer, and a Qualified Person as defined under National Instrument 43-101. Mr. Matheson consents to the publication of this news release dated May 21, 2021 by New Found. Mr. Matheson certifies that this news release fairly and accurately represents the information for which he is responsible.
About New Found Gold Corp. New Found holds a 100% interest in the Queensway Project, located 15km west of Gander, Newfoundland, and just 18km from Gander International Airport. The project is intersected by the Trans-Canada Highway and has logging roads crosscutting the project, high voltage electric power lines running through the project area, and easy access to a highly skilled workforce. The Company is currently undertaking a 200,000m drill program at Queensway. Seven rigs are currently in operation at Queensway with the drill count planned to increase to ten rigs by Q2 2021. With a current working capital balance of approximately $79 million, New Found is well funded for this program.
Acknowledgements New Found acknowledges the financial support of the Junior Exploration Assistance Program, Department of Natural Resources, Government of Newfoundland and Labrador.
Contact To contact the Company, please visit the Company's website, www.newfoundgold.ca and make your request through our investor inquiry form. Our management has a pledge to be in touch with any investor inquiries within 24 hours.
New Found Gold Corp. Per: "Craig Roberts"
Neither the TSX Venture Exchange nor its Regulation Services Provider (as that term is defined in the policies of the TSX Venture Exchange) accepts responsibility for the adequacy or accuracy of this release.
Forward-Looking Statement Cautions This press release contains certain "forward-looking statements" within the meaning of Canadian securities legislation, relating to further the exploration and drilling on the Company's Queensway gold project in Newfoundland. Although the Company believes that such statements are reasonable, it can give no assurance that such expectations will prove to be correct. Forward-looking statements are statements that are not historical facts; they are generally, but not always, identified by the words "expects," "plans," "anticipates," "believes," "intends," "estimates," "projects," "aims," "potential," "goal," "objective," "prospective," and similar expressions, or that events or conditions "will," "would," "may," "can," "could" or "should" occur, or are those statements, which, by their nature, refer to future events. The Company cautions that forward-looking statements are based on the beliefs, estimates and opinions of the Company's management on the date the statements are made, and they involve a number of risks and uncertainties. Consequently, there can be no assurances that such statements will prove to be accurate and actual results and future events could differ materially from those anticipated in such statements. Except to the extent required by applicable securities laws and the policies of the TSX Venture Exchange, the Company undertakes no obligation to update these forward-looking statements if management's beliefs, estimates or opinions, or other factors, should change. Factors that could cause future results to differ materially from those anticipated in these forward-looking statements include risks associated possible accidents and other risks associated with mineral exploration operations, the risk that the Company will encounter unanticipated geological factors, the possibility that the Company may not be able to secure permitting and other governmental clearances necessary to carry out the Company's exploration plans, the risk that the Company will not be able to raise sufficient funds to carry out its business plans, and the risk of political uncertainties and regulatory or legal changes that might interfere with the Company's business and prospects. The reader is urged to refer to the Company's reports, publicly available through the Canadian Securities Administrators' System for Electronic Document Analysis and Retrieval (SEDAR) at www.sedar.com for a more complete discussion of such risk factors and their potential effects.
Share this article